Getting the E63 connected to Asterisk was a bit trying at first, since the included VOIP client seems to be tailored to a Nokia VOIP solution. With some trial and error, then some googling, I was able to get it working, and now my E63 is not only a cellphone with uber connectivity options, but also doubles as an extension of my office PBX! What is most impressive about this setup is that the phone “knows” when it is at the office and automatically switches on the VOIP client and allows the phone to call or receive calls through the PBX, thereby saving valuable minutes while at the office.
Here’s how I got the NOKIA E63 to act as a VOIP client on my office PBX.
First, open the Menu -> Tools -> Settings -> Connection settings. In there, you will see an item that says “SIP Settings”
Once in the SIP settings, you’ll be able to enter the configuration options for your SIP extension on your PBX. First, create a SIP Profile and then enter the SIP account info in the new SIP profile.
The options one can enter here are:
- Profile Name (specify whatever you wish)
- Service Profile (should be IETF)
- Default Access Point (I used the wifi access point in my office SSID iWay)
- Public User Name (Here specify as firstname.lastname@example.org) ie. email@example.com if 200 is your SIP extension account
- Use Compression (set this to NO)
- Registration (set to Always On)
- Use Security (I selected NO)
The last 2 items are for entering the proxy and registrar servers (basically the account info and address of your PBX for both incoming and outgoing channels).
For the Proxy server submenu please enter the following information:
- Proxy Server Address (this should be the FQDN or IP address of your PBX) in my example, it was asterisk.iwayvietnam.com
- Realm (If you are using Asterisk as your PBX set this to the word “asterisk”)
- User Name (set this to JUST your extension number, I used 200)
- Password (this is case sensitive, enter exactly as it is in the Asterisk GUI manager for the SIP account)
- Allow Loose Routing (Set this to YES)
- Transport Type (set this to AUTO)
- Port (make sure this says 5060)
Ok, now go back to the previous menu level and now select Registrar Server. Please enter your info similar to the folowing:
- Registrar Server Address (again, this should be the FQDN or IP of your PBX) I used asterisk.iwayvietnam.com
- Realm (again, just set this to “asterisk” no quotes)
- User Name (ONLY your extension number)
- Password (you know what this is by now….)
- Transport Type (AUTO)
- Port (5060)
Now back out of the menu to the previous level, then hit BACK again. If all went right, you should see status of that new SIP profile is “Registered”.
You’re almost done, just a couple more steps to complete your E63 VOIP configuration. Now go back to the Connection setup menu in the Settings menu. Look for an item called “Internet Tel.” and click on that to create a new Internet Telephone profile. It is here that you will select your default SIP profile and specify how it will connect. To begin, just select Options, then New Profile.
Once done, back out and go to the Menu -> Communication menu and then select Options, Settings…
For default Call type select “Internet Call”. Now exit all the menus. If your phone sees your wireless network
and your SIP extension account is active on the PBX, you should see this on your screen (note arrows) to indicate that your VOIP client is now ready to receive or make a call using your PBX instead of cellular minutes. Also, when you leave your wifi zone, the phone will automatically turn off and deactivate the VOIP client until you return within your wifi’s coverage zone.
Congratulations, if you see these two additional marks on your screen, you now have a working VOIP extension on your phone!
Enjoy and please comment below.